Home - News - Details

How Can Silica Gel Stick To Metal?

Bonding material description: craft product keychain, made of stainless steel surface plating, the surface is very smooth.

The craft product keychain is decorated with silicone sheet, and the bonding surface is very smooth and greasy.

Special glue and stainless steel surface plating products to be bonded.

Silicone treatment agent and silicone product to be bonded


Metal surface treatment: Dip a small amount with a small brush, apply evenly on the surface of the product to be bonded with a treatment agent, dry it naturally for about 30 minutes, or heat it to dry.

The silicone treatment agent is evenly applied to the surface of the product to be bonded.

Note: Bonding must be done within 1 minute after applying the treatment agent, otherwise the ideal bonding effect will not be achieved.

After the surface of the product needs to be bonded, the metal-specific glue is used on the bonding surface of the product. It should not be too much. The bonding surface of the product is about 25mm in diameter. It is enough to drop three small dots.

After the glue is applied, the silicone sheet is attached to the metal piece and pressed tightly so that the contact surface of the product is completely matched, positioned for 10-15 seconds, and the operable strength is reached after 30 minutes. The ideal bonding effect is achieved in 12 hours.

Finishing the bonding effect, forcibly tearing will destroy the silicone trim.

Send Inquiry

You Might Also Like