Need to pay attention to the above when producing silicone cup bottom sleeves?

I believe that many people have used silicone cup sleeves. Silicone cup cover can set off the high-end cups, and can also be anti-scalding, anti-skid, anti-drop, etc.

As for the silicone cup bottom cover, it is required not to be too thin, the thinnest place is 1.5mm, and the thickest place is at the bottom, because it can withstand a glass of water. Putting it on the table will not hear the sound of the thermos cup, and minimize the knocking noise.

Then the bottom cover of the silicone cup, the inner side is polished and electroplated, and the outer side is matte frosted texture, so the inner side of the silicone cover has good adsorption. It can tightly fit the thermos cup, and it is not easy to be loosened by a little external force. Of course, you can also deliberately fall off with a little effort by hand.

And the silicone cup bottom cover needs an air outlet at the bottom. When the cup is covered with silicone, the air in the cup cover can be easily squeezed out.

This reduces the difficulty of the sleeve, and the silicone can also easily adjust the shape at any time when it is not sleeved, and it will not be difficult to install due to excessive pressure.

Its LOGO and characters are generally designed on the inside of the cup cover, but of course they can also be made on the outside. The characters are recessed and will not press your hands.